Removal Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Front Bumper Fascia Center Air Deflector Screw (1) - Remove [10x]
Front Bumper Fascia Center Air Deflector Screw (1) - Remove [3x]
Front Bumper Fascia Center Air Deflector Screw (1) - Remove [6x]
- Front Bumper Fascia Center Air Deflector Bolt (2) - Remove [5x]
- Front Bumper Fascia Center Air Deflector Retainer (3) - Remove [2x]
Pull the front bumper fascia center air deflector (1) rearward and down from the front bumper fascia.
Radiator Air Front Lower Baffle Retainer (1) - Remove [3x]
Radiator Air Front Lower Baffle (1) - Remove
Radiator Air Lower Seal Retainer (1) - Remove [6x]
- Radiator Air Lower Baffle (2) - Remove
Radiator Air Seal Retainer- Left Side (1) - Remove [2x]
Radiator Air Seal Retainer- Right Side (1) - Remove [2x]
- Lower the vehicle.
Radiator Air Upper Baffle Retainer (1) - Remove [7x]
- Radiator Air Upper Baffle (2) - Remove
Wiring Harness Retainer (1) - Remove
- Radiator Upper Bracket Bolt (3) - Remove [4x]
- Radiator Upper Bracket (2) - Remove [2x]
Air Conditioning Evaporator Tube Clip Bolt (1) - Remove
- Air Conditioning Evaporator Tube Bracket (2) - Reposition
- Engine Coolant Fan Electrical Connector (3) @ Forward Lamp Wiring Harness (4) - Disconnect
Wiring Harness Retainer (1) @ Air Cleaner Assembly - Remove [3x]
- Positive Crankcase Ventilation Tube (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Evaporative Emission Canister Purge Tube (3) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Electrical Connector (4) - Disconnect [2x]
Air Cleaner Bolt (1) - Remove
- Air Cleaner Outlet Duct Clamp (2) - Loosen
Remove the air cleaner (1) and air cleaner outlet duct (2) as an assembly.
Radiator Outlet Pipe Clip (4) - Remove
- Radiator Inlet Pipe (3) - Reposition away
Air Conditioning Condenser Tube Clip (1) @ Engine Cooler Fan (2) - Remove
Charge Air Cooler Bolt (1) - Remove [2x]
- Without disconnecting the charge air inlet and outlet cooler tubes, lift up on the charge air cooler (2) and reposition.
Lift upward on the engine radiator (1) until the 2 radiator lower insulators (2) have sufficient clearance.
- Radiator Lower Insulator (2) - Remove [2x]