Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front bumper fascia. Front Bumper Fascia Removal and Installation (without Blackwing) , or Front Bumper Fascia Removal and Installation (with Blackwing) , or Front Bumper Fascia Removal and Installation (with Blackwing CFV, CFZ)
Auxiliary Radiator Duct Retainer (1) - Remove [3x]
Auxiliary Radiator Duct Retainer (1) - Remove [2x]
- NOTE:
The front bumper fascia support brace (2) may have a forward range radar sensor attached, if equipped.
Front Bumper Fascia Support Brace Bolt (1) - Remove [3x]
- Front Bumper Fascia Support Brace (2) - Remove
- Disconnect the electrical connector from the forward range radar sensor, if equipped.
Intake Air Duct Retainer (1) - Remove [2x]
- Radiator Air Lower Seal Retainer (2) - Remove [2x]
- Radiator Air Lower Baffle Retainer (3) - Remove [2x]
Front End Sheet Metal Cross Brace Bolt (1) - Remove [4x]
- Front End Sheet Metal Cross Brace (2) - Remove [2x]
Horn Bolt (1) - Remove [2x]
- Horn (2) - Reposition [2x]
Reposition the wiring harness.
- Front Bumper Impact Bar Bolt (1) - Remove [8x]
- Front Bumper Impact Bar (2) - Remove
Auxiliary Radiator Front Duct (1) - Remove