LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Engine Heating And Cooling - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P112F >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify there are no DTCs set, except DTC P112F, related to the following system/component:

    B203 Radiator Coolant Temperature Sensor

    • Go to next step: If a related DTC is not set 
  3. Verify there are no DTCs set related to the following component/system:
    • B9 Ambient Air Temperature Sensor
    • B34 Engine Coolant Temperature Sensor
    • B36 Engine Oil Temperature Sensor
    • B65 Manifold Absolute Pressure and Intake Air Temperature Sensor
    • Go to next step: If a related DTC is not set 
  4. Verify the following scan tool Freeze Frame/Failure Records parameters are within 15.8°C (28°F) of each other:
    • Start-Up Engine Coolant Temperature Sensor
    • Start-Up Engine Coolant Temperature Sensor 2
    • Start-Up Engine Coolant Temperature Sensor 5
    • Start-Up Engine Coolant Temperature Sensor 6
    • Start-Up Radiator Coolant Temperature Sensor
    • If not within 15.8°C (28°F) of each other 
    1. Ignition/Vehicle - Off
      2. NOTE:

      Test the sensor that is colder or warmer than the other temperature sensor(s).

    2. Disconnect the electrical connector: B203 Radiator Coolant Temperature Sensor
    3. Disconnect the appropriate electrical connector: K20 Engine Control Module
    4. Test for less than 2 ohms between the test points: Low Reference circuit terminal 2/B@Component harness & The other end of the circuit@Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • Go to next step: If less than 2 ohms
    5. Test for less than 2 ohms between the test points: Signal circuit terminal 1/A@Component harness & The other end of the circuit@Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • Go to next step: If less than 2 ohms
    6. Test or replace the component: B203 Radiator Coolant Temperature Sensor
    • Go to next step: If within 15.8°C (28°F) of each other 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Repeat the procedure starting at step 1

    • Go to next step: If the DTC is not set 
  6. All OK.
scientia non olet · About LEMON Manuals