LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Mechanical - 3.6L (LF4) - Repair Instructions (1 Of 4)) >> Repair Instructions >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5841339

    Air Cleaner Outlet Duct Clamp (1) - Loosen

  2. Air Cleaner Outlet Duct (2) - Reposition
  3. Air Cleaner Outlet Duct Clamp (3) - Loosen
  4. Auxiliary Air Cleaner Outlet Duct (4) - Reposition
  5. Remove all retainers from the air cleaner upper housing.
  6. Disconnect the 2 mass airflow sensor electrical connectors.
  7. GM5841341

    Air Cleaner Housing Cover Bolt (1) - Remove [13x]

  8. Air Cleaner Upper Housing (2) - Remove
  9. GM5854879
    NOTE:
    • Observe the location and routing of the accessory drive primary belt to ensure proper installation.
    • Some components not shown for graphic clarity.

    Use a suitable tool to rotate the drive belt tensioner (1) counterclockwise to relieve tension from the accessory drive primary belt (2).

  10. Remove the accessory drive primary belt (2) from the pulleys and tensioner (1).
  11. Slowly release tension on the drive belt tensioner (1).
  12. Clean and inspect the drive belt surfaces of all the pulleys.
  13. GM5854905
    NOTE:

    Some components not shown for graphic clarity.

    Drive Belt Tensioner Bolt (1) - Remove

  14. Drive Belt Tensioner (2) - Remove
scientia non olet · About LEMON Manuals