LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Mechanical - 3.6L (LF4) - Repair Instructions (1 Of 4)) >> Repair Instructions >> Compressor Air Intake Turbocharger Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (LF4 Static Fill) , or Cooling System Draining and Filling (LF4 GE 47716)
  2. Oil Filler Cap - Remove
  3. GM5839283

    Intake Manifold Cover Bolt (1) - Remove

  4. Intake Manifold Cover (2) - Remove
  5. Install the oil filler cap after removal of the intake manifold cover to prevent debris from falling into the engine.
  6. GM5846598
    CAUTION:

    The Positive Crankcase Ventilation (PCV) line is tamper resistant and must always be replaced once it is removed. The fittings connected to the PCV line must also be replaced if they are damaged when the PCV line is removed. To reduce the risk of damage to the fittings, use a suitable cutting tool and carefully cut the connections away.

    Using a suitable cutting tool, carefully cut the 2 positive crankcase ventilation tube connectors (1).

  7. Positive Crankcase Ventilation Fresh Air Tube (2) - Remove and DISCARD
  8. GM5860356

    Turbocharger Wastegate Actuator Vacuum Tank Solenoid Valve Tube (1) - Disconnect and reposition - Plastic Collar Quick Connect Fitting Service

  9. Air Cleaner Outlet Duct Clamp (2) - Loosen
  10. GM5860357

    Charge Air Bypass Valve Hose Clamp (1) - Loosen

  11. Charge Air Bypass Valve Hose (2) - Reposition
  12. Retainer Spring (3) - Disengage
  13. GM5860358

    Auxiliary Air Cleaner Outlet Duct (1) - Remove

  14. GM5873802

    Retaining Clip (1) - Remove

  15. GM5873812

    Turbocharger Coolant Feed and Return Pipe Bolt (1) - Remove

  16. Turbocharger Coolant Feed and Return Pipe Gasket (2) - Remove and DISCARD [2x]
  17. Turbocharger Coolant Return Pipe (3) - Remove
  18. GM5875351
    NOTE:

    Some components not shown for graphic clarity.

    Positive Assurance Cap (1) - Reposition

  19. Using a suitable tool, remove the turbocharger oil feed pipe fitting clip (2).
  20. GM5879148

    Turbocharger Heat Shield Bolt (1) - Remove [2x]

  21. Raise and support the vehicle. Lifting and Jacking the Vehicle
  22. GM5395705

    Rear Tire Front Air Deflector Bolt- Left Side and Right Side (1) - Remove [4x]

  23. Rear Tire Front Air Deflector- Left Side and Right Side (2) - Remove [2x]
  24. GM5400553

    Rear Wheelhouse Liner Bolt- Left Side (1) - Remove

  25. Underbody Rear Air Deflector Nut- Left Side (2) - Remove [3x]
  26. Underbody Rear Air Deflector Bolt- Left Side (3) - Remove [3x]
  27. Underbody Rear Air Deflector Nut- Left Side (4) - Remove [2x]
  28. Underbody Rear Air Deflector- Left Side (5) - Remove
  29. GM5400642

    Rear Wheelhouse Liner Bolt- Right Side (1) - Remove

  30. Underbody Rear Air Deflector Bolt- Right Side (2) - Remove [3x]
  31. Underbody Rear Air Deflector Nut- Right Side (3) - Remove [3x]
  32. Underbody Rear Air Deflector Nut- Right Side (4) - Remove [2x]
  33. Underbody Rear Air Deflector- Right Side (5) - Remove
  34. GM5400756

    Floor Panel Number 4 Cross Bar Reinforcement Bolt (1) - Remove [6x]

  35. Floor Panel Reinforcement (2) - Remove
  36. GM5865265

    Catalytic Converter Nut (1) - Remove [2x]

  37. GM5865271

    Exhaust Pipe Clamp (1) - Loosen [2x]

  38. GM5406578

    Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator-Left Side (2) - Separate [2x]

  39. GM5406632

    Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator-Right Side (2) - Separate [2x]

  40. GM5865287

    Electrical Connector (1) - Disconnect

  41. GM5865293

    Electrical Connector (1) - Disconnect

  42. GM5865300
    NOTE:

    The rear bumper fascia is removed for illustration purposes only.

    Exhaust Muffler Hanger Bracket Nut (1) - Remove [4x]

  43. GM5865329

    With the aid of an assistant, remove the exhaust muffler (1).

  44. Catalytic Converter Gasket (2) - Remove and DISCARD
  45. GM5872016

    Catalytic Converter Brace Bracket Nut (1) - Remove [5x]

  46. Catalytic Converter Brace (2) - Remove
  47. Disconnect the heated oxygen sensor electrical connector.[2x]
  48. GM5872256

    Catalytic Converter Nut (1) - Remove [4x]

  49. GM5872277

    Warm Up Three-Way Catalytic Converter (1) - Remove

  50. Turbocharger Exhaust Pipe Gasket (2) - Remove and DISCARD
  51. GM5879181

    Turbocharger Heat Shield Bolt (1) - Remove

  52. GM5879216

    Turbocharger Heat Shield (1) - Remove

  53. GM5875352
    NOTE:

    Some components not shown for graphic clarity.

    Turbocharger Oil Feed Pipe Bolt (1) - Remove

  54. Turbocharger Oil Feed Pipe Washer (2) - Remove and DISCARD
  55. Turbocharger Oil Feed Pipe (3) - Remove
  56. GM5874904
    NOTE:

    Some components not shown for graphic clarity.

    Turbocharger Oil Return Pipe Bolt (1) - Remove [4x]

  57. GM5874905
    NOTE:

    Some components not shown for graphic clarity.

    Turbocharger Oil Return Pipe (1) - Remove

  58. Turbocharger Oil Return Pipe Gasket (2) - Remove and DISCARD [2x]
  59. GM5892303

    Turbocharger Coolant Feed and Return Pipe Bolt (1) - Remove

  60. Turbocharger Coolant Feed and Return Pipe Gasket (2) @ Compressor Air Intake Turbocharger - Remove and DISCARD [2x]
  61. Turbocharger Coolant Feed Pipe (3) @ Compressor Air Intake Turbocharger - Separate
  62. GM5880453

    Turbocharger Bolt (1) - Remove [4x]

  63. GM5880454

    Compressor Air Intake Turbocharger (1) - Remove

  64. Turbocharger Gasket (2) - Remove and DISCARD
scientia non olet · About LEMON Manuals