Component Testing

Static Test

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: Q40 Turbocharger Bypass Valve Solenoid
3. Test for 20 to 27 ohms between the test points: Control terminal 2 & Ignition terminal 1
   • If not between 20 and 27 ohms 

     Replace the component: Q40 Turbocharger Bypass Valve Solenoid

   • Go to next step: If between 20 and 27 ohms 
4. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
   • If less than infinite resistance 

     Replace the component: Q40 Turbocharger Bypass Valve Solenoid

   • Go to next step: If infinite resistance 
5. All OK.

Dynamic Test

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: Q40 Turbocharger Bypass Valve Solenoid
3. Connect a 10 A fused jumper wire between the test points: Ignition terminal 1 & 12 V
CAUTION:

Complete the testing as quickly as possible in order to prevent overheating and damaging the component.

5. Momentarily connect a jumper wire between the test points: Control terminal 2 & Ground

   Verify the component produces a clicking sound: Q40 Turbocharger Bypass Valve Solenoid

   • If a click cannot be heard or felt 

     Replace the component: Q40 Turbocharger Bypass Valve Solenoid

   • Go to next step: If a click can be heard or felt 
6. All OK.