Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the charge air cooling system. Cooling System Draining and Filling (LSY GE 47716) , or Cooling System Draining and Filling (LSY Static Fill) , or Cooling System Draining and Filling (LSY with V03 Static Fill) , or Cooling System Draining and Filling (L3B Static Fill) , or Cooling System Draining and Filling (L3B GE 47716) , or Cooling System Draining and Filling (LSY with V03 GE 47716) , or Cooling System Draining and Filling (LF4 Static Fill) , or Cooling System Draining and Filling (LF4 GE 47716)
- Oil Filler Cap - Remove
Intake Manifold Cover Bolt (1) - Remove
- Intake Manifold Cover (2) - Remove
- Install the oil filler cap after removal of the intake manifold cover to prevent debris from falling into the engine.
Disconnect the turbocharger wastegate regulator solenoid valve electrical connector (1).
- Engine Wiring Harness Retainer (2) - Disconnect [2x]
Disengage the 2 turbocharger wastegate actuator vacuum tank solenoid valve tube clamps (1).
- Retainer (2) - Disengage
- Turbocharger Wastegate Actuator Vacuum Tank Solenoid Valve Tube (3) @ Auxiliary Air Cleaner Outlet Duct - Disconnect - Plastic Collar Quick Connect Fitting Service
- Turbocharger Wastegate Actuator Vacuum Tank Solenoid Valve Tube (4) - Remove
Charge Air Cooler Coolant Hose Clamp (1) - Disengage - Hose Clamp Replacement Guidelines - Spring Type
- Charge Air Cooler Coolant Hose (2) - Remove
- Charge Air Cooler Coolant Hose Clamp (3) - Disengage - Hose Clamp Replacement Guidelines - Spring Type
- Charge Air Cooler Coolant Hose (4) - Remove
Charge Air Cooler Coolant Manifold Bolt (1) - Remove [4x]
Supercharger Water Manifold (1) - Remove
- Supercharger Water Manifold Gasket (2) - Remove and DISCARD [2x]
- Charge Air Cooler Coolant Pipe Seal (3) - Remove and DISCARD [4x]
Evaporative Emission Canister Purge Tube (1) @ Evaporative Emission Canister Purge Solenoid Valve - (2) Disconnect - Plastic Collar Quick Connect Fitting Service
Tie Strap (1) - Remove and DISCARD
- Evaporative Emission Canister Purge Tube (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
Evaporative Emission Canister Purge Solenoid Valve Bracket Bolt (1) - Remove
- Evaporative Emission Canister Purge Solenoid Valve (2) - Remove