Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set related to the following component/system:
- B23 Camshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B52 Heated Oxygen Sensor
- B74 Manifold Absolute Pressure Sensor
- B75 Mass Airflow Sensor
- B111B Turbocharger/Supercharger Boost Pressure and Intake Air Temperature Sensor
- B150 Fuel Tank Pressure Sensor
- Q12 Evaporative Emission Canister Purge Solenoid Valve
- Q17 Fuel Injector
- Q38 Throttle Body
- Engine Misfire
- Evaporative Emission (EVAP) System
- Fuel Trim System
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Verify the following conditions do not exist:
- Air Cleaner Element - Dirty/Missing/Restricted/Visible Damage/Water intrusion
- Engine - Vacuum leak
- Evaporative Emission (EVAP) Purge System - Leaking/Stuck Open
- Evaporative Emission (EVAP) System - Leaking/Saturated with fuel/Visible Damage
- Exhaust System - Leaking/Restricted - Refer to: Symptoms - Engine Exhaust
- Fuel - Contaminated/Fill Level = Low/Poor Quality - Refer to: Alcohol/Contaminants-in-Fuel Diagnosis
- Fuel Injectors - Leaking/Restricted - Refer to: Fuel Injector Diagnosis
- Fuel Pressure - High/Low - Refer to: Fuel System Diagnosis
- Intake Air Duct - Leaking/Loose/Poor Connection/Restricted/Visible Damage
- Positive Crankcase Ventilation System - Dirty/Leaking/Poor Connection/Restricted
- Throttle Body - Blocked/Dirty/Restricted
- Vacuum Hoses - Incorrect connection/Kinked/Leaking/Restricted
- Vacuum leak @ Engine - Oil Level Indicator and Tube /Oil Filler Cap
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
A condition with the system still exists - Refer to: Step 3
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.