Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Position the NEW clutch pilot bearing to the rear of the crankshaft.
- Assemble the GE - 8433 Universal Bridge Puller (2), and the EN - 45949 Pilot Bearing and Flywheel Locator Installer (1) and bolts to the rear of the crankshaft.
- Tighten the bolts until snug.
- Rotate the bolt of the GE - 8433 Universal Bridge Puller (2) until the clutch pilot bearing is seated in the bore of the crankshaft.
- Remove the GE - 8433 Universal Bridge Puller (2), and the EN - 45949 Pilot Bearing and Flywheel Locator Installer (1).
Inspect the clutch pilot bearing for proper installation.
- Install the manual transmission to the vehicle. Manual Transmission Removal and Installation