Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Remove the manual transmission from the vehicle. Manual Transmission Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Install the EN-50792 Flywheel Holding Tool (1).
Fig 1: Clutch Pressure Plate Bolts Loosening Sequence
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- If reusing the pressure plate assembly, place an alignment mark on the pressure plate and flywheel for proper alignment during installation.
- DO NOT use air tools to remove the clutch pressure plate bolts
Loosen the clutch pressure plate bolts using the following sequence:
1. Loosen bolts 1 and 2 one full turn, then stop.
2. Loosen bolts 3 and 4 one full turn, then stop.
3. Loosen bolts 5 and 6 one full turn, then stop.
4. Repeat Steps 3.1 through 3.3 until all bolts are loose.
Courtesy of GENERAL MOTORS COMPANY

Clutch Pressure Plate Bolt (1) - Remove and DISCARD [6x]
Courtesy of GENERAL MOTORS COMPANY

Remove the clutch pressure plate (2) from the dowel pins on the flywheel.
Remove the driven disc (3).