Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P0641, P0651, P0697, P06A3, P08A8-P08AA is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Inspect the component for wear or damage: Clutch Pedal - Refer to: Symptoms - Clutch
- If a condition exists
Repair or replace as necessary
- Go to next step: If no conditions exist
- If a condition exists
- Perform the following learn procedure: Clutch Pedal Position Learn
- If the procedure was not successful
Replace the component: K20 Engine Control Module
- Go to next step: If the procedure was successful
- If the procedure was not successful
- All OK.