Component Testing
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: B13M Manual Transmission Fluid Temperature Sensor
- Test for 15 to 150, 000 ohms between the test points: Signal terminal 2/B & Low Reference terminal 1/A
- If not between 15 and 150, 000 ohms
Replace the component: B13M Manual Transmission Fluid Temperature Sensor
- Go to next step: If between 15 and 150, 000 ohms
- If not between 15 and 150, 000 ohms
- Verify the value is within the range listed in the table: Temperature Versus Resistance - B13M Manual Transmission Fluid Temperature Sensor
- If not in the specified range
Replace the component: B13M Manual Transmission Fluid Temperature Sensor
- Go to next step: If in the specified range
- If not in the specified range
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: B13M Manual Transmission Fluid Temperature Sensor
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.