With Scan Tool
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Select: Module Diagnostics
- Select: Engine Control Module
- Select: Configuration/Reset Functions
- Select: Reset Functions
- Select: Excessive Clutch Slip Data Reset
- Select: Reset
- Verify the scan tool parameter:
- Excessive Clutch Slip Counter - After Gear Change without Clutch = 0
- Excessive Clutch Slip Counter - After Gear Change = 0
- Excessive Clutch Slip Counter - Clutch Engaged = 0
- If not the specified value
Repeat the procedure starting at step 1
- Go to next step: If the specified value
- All OK.