Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Seat Adjuster Memory Module Bracket (2) - Install
Position the wiring harness.

CAUTION:

Refer to Fastener Caution .

Front Seat Adjuster Memory Module Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Driver or Passenger Seat Adjuster Memory Module (1) - Install
Connect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Front Seat Heater Vent Control Module (2) - Install
Front Seat Heater Vent Control Module Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Pad Front Support (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Airbag Front Passenger Presence Module (2) - Install
Install the airbag front passenger presence module sensor onto the bracket.
Connect the electrical connector.
Airbag Front Passenger Presence Module Retainer (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Cover and Pad (2) - Install - Front Seat Cushion Cover and Pad Removal and Installation (Blackwing)

NOTE:

The Regulatory Name for this component because of SAE J1930 is Restraints Occupant Classification System Module.

Perform the necessary programming and setup procedure:Control Module References