Component Testing

Front Seat Adjuster Memory Switch

1. Ignition/Vehicle OFF, disconnect the connector at the S47 Front Seat Adjuster Memory Switch.
2. Test for infinite resistance between each signal terminal listed below and the ground terminal 2 with the switch in the open position.
   • Terminal 3
   • Terminal 4
   • If less than infinite resistance 

     Replace the S47 Front Seat Adjuster Memory Switch.

   • Go to next step: If infinite resistance 
3. Test for less than 4 Ω between the signal terminal 4 and the ground terminal 2 while pressing the memory SET button.
   • If 4 Ω or greater 

     Replace the S47 Front Seat Adjuster Memory Switch.

   • Go to next step: If less than 4 Ω 
4. Test for 1140 - 1400 Ω between the signal terminal 3 and the ground terminal 2 while pressing the memory 1 button.
   • If not between 1140 - 1400 Ω 

     Replace the S47 Front Seat Adjuster Memory Switch.

   • Go to next step: If between 1140 - 1400 Ω 
5. Test for 3790 - 4630 Ω between the signal terminal 3 and the ground terminal 2 while pressing the memory 2 button.
   • If not between 3790 - 4630 Ω 

     Replace the S47 Front Seat Adjuster Memory Switch.

   • Go to next step: If between 3790 - 4630 Ω 
6. Test for 11.4 - 13.9 kΩ between the signal terminal 3 and the ground terminal 2 while pressing the Exit button.
   • If not between 11.4 - 13.9 kΩ 

     Replace the S47 Front Seat Adjuster Memory Switch.

   • Go to next step: If between 11.4 - 13.9 kΩ 
7. All OK.