Removal Procedure
Reposition the seat as necessary to access the retaining clips.
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Left Side (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Right Side (1) - Remove
Front Floor Console Bolt (1) - Remove [6x]
- Front Floor Console Bracket Bolt (2) - Remove [2x]
- Release the tabs (3) on both sides of the front floor console.
Slide the front floor console (1) enough to clear the instrument panel lower center trim panel.
Front Floor Console Variable 1 Liner (1) - Remove
Using a suitable non-marring tool, carefully pry in the area of the arrows between the automatic transmission control lever knob boot (1) and the front floor console trim plate (2) and release the automatic transmission control lever knob boot.
Remove the automatic transmission control lever knob (1) by pulling up and releasing the retainer.
- Disconnect the electrical connector (3).
- Front Floor Console Trim Plate Bolt (4) - Remove [2x]
Front Floor Console Trim Plate (1) - Remove
- NOTE:
The automatic transmission range selector lever cable bolt is retained in the automatic transmission range selector lever cable.
Loosen the automatic transmission range selector lever cable bolt (1) to disengage the threads from the transmission control.
- Remove the automatic transmission range selector lever cable to automatic transmission control bolt (2).
Automatic Transmission Control Bolt (1) - Remove [2x]
- Automatic Transmission Control Bolt (2) - Remove
Automatic Transmission Control (1) - Remove