Removal Procedure
Front Bumper Fascia (1) - Remove - Front Bumper Fascia Removal and Installation
- Reposition the wiring harness.
Release the retaining tabs on the front bumper fascia and pull the front bumper fascia energy absorber (1) from the front bumper fascia.
Front Bumper Shutter Bolt (1) - Remove [6x]
- Front Bumper Shutter (2) - Remove
Remove the 2 left and right side front side marker lamp screws (1).
- Remove the 2 left and right side front side marker lamps (2).
Lift the locking tabs on the housing and remove the 4 object sensors (1).
Remove the 2 short range radar sensor bolts (1)
- Short Range Radar Sensor (2) - Remove [2x]
Front Grille Clip (1) - Remove [2x]
- Front Grille (2) - Remove
Front Lower Grille Clip (1) - Remove [4x]
- Front Lower Grille (2) - Remove
Front Bumper Upper Fascia (1) - Remove