Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia (1) - Remove - Front Bumper Fascia Removal and Installation
Remove the wiring harness.
Courtesy of GENERAL MOTORS COMPANY

Release the retainer tabs on the front bumper fascia and pull the energy absorber from the front bumper fascia.
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Shutter Bolt (1) - Remove [6x]
Front Bumper Shutter Frame (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Remove the left and right side front side marker lamp screw (1).
Remove the left and right side front side marker lamp (2).
Courtesy of GENERAL MOTORS COMPANY

Lift the locking tabs on the housing and remove the 4 object sensor (1).
Courtesy of GENERAL MOTORS COMPANY

Remove the 2 short range radar sensor bolts (1)
Short Range Radar Sensor (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Grille Clip (1) - Remove [2x]
Front Grille (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Lower Grille Clip (1) - Remove [4x]
Front Lower Grille (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Grille Clip- Left Side and Right Side (1) - Remove [2x]
Release the left side and right side front bumper fascia molding retaining tabs.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Bumper Fascia Molding- Left Side and Right Side (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Upper Fascia (1)