Removal Procedure
- Place the ignition switch in the OFF position.
- Apply and release the brake pedal several times until the brake pedal becomes firm to deplete the power brake booster vacuum reserve.
- Instrument Panel Lower Trim Panel Replacement - Left Side - Remove - Instrument Panel Lower Trim Panel Insulator Replacement - Left Side
Brake Pedal Retainer (1) @ Brake Pedal (2) - Release
- Brake Pedal Retainer - Remove and DISCARD
- Brake Master Cylinder - Remove - Brake Master Cylinder Replacement (LGX)
Disconnect the power vacuum brake booster vacuum sensor electrical connector.
- Remove the power vacuum brake booster vacuum sensor (1) and hose assembly and position aside.
Power Vacuum Brake Booster Bolt (1) - Loosen [2x]
Power Vacuum Brake Booster (1) - Remove