Component Testing
Instrument Panel Compartment Door Release Actuator
- Ignition/Vehicle Off. Disconnect the harness connector at the M91 Instrument Panel Compartment Door Unlatch Actuator.
- Install a 10 A fused jumper wire between the control terminal 1 and 12 V. Install a jumper wire between the ground terminal 2 and ground.
- Verify the M91 Instrument Panel Compartment Door Unlatch Actuator activates.
- If the M91 Instrument Panel Compartment Door Unlatch Actuator does not activate.
Replace the M91 Instrument Panel Compartment Door Unlatch Actuator.
- Go to next step: If the M91 Instrument Panel Compartment Door Unlatch Actuator does activate.
- If the M91 Instrument Panel Compartment Door Unlatch Actuator does not activate.
- All OK.