LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> XTS Livery >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Assembly Replacement (With Accelerator and Bracket) >> Removal Procedure

Removal Procedure

  1. Remove the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement .
  2. Disconnect the accelerator pedal position sensor electrical connector.
  3. GM2347572Courtesy of GENERAL MOTORS COMPANY

    Pull the brake pedal (1) rearward to release the power vacuum brake booster pushrod retainer.

    4. NOTE:

    Do not reuse the power vacuum brake booster pushrod retainer.

  4. Remove and discard the power vacuum brake booster pushrod retainer.
  5. GM2384679Courtesy of GENERAL MOTORS COMPANY

    Remove the left upper brake and accelerator pedal assembly bolts (1).

  6. GM2384682Courtesy of GENERAL MOTORS COMPANY

    Remove the right upper brake and accelerator pedal assembly bolts (1).

  7. Remove the instrument panel tie bar. Refer to Instrument Panel Tie Bar Replacement .
  8. Remove the power vacuum brake booster. Refer to Power Vacuum Brake Booster Replacement .
  9. GM2753651Courtesy of GENERAL MOTORS COMPANY

    Remove the brake pedal assembly nuts (1).

  10. Remove the brake pedal assembly.
  11. Remove the accelerator pedal position sensor. Refer to Accelerator Pedal Position Sensor Replacement .
scientia non olet · About LEMON Manuals