LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> XTS Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Automatic Transmission - 6T70 (M7U M7W), 6T75 (M7V), Or 6T80 (Mhm) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Front Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2199370Courtesy of GENERAL MOTORS COMPANY

    Install the transmission mount (1).

  2. Raise the vehicle.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the NEW transmission mount bolts (2) and tighten to 62 N.m (46 lb ft).
  4. GM2199369Courtesy of GENERAL MOTORS COMPANY

    Install the transmission mount through bolt (1) and tighten to 100 N.m (79 lb ft).

  5. Install the wire harness retainer at the front transmission mount bracket.
  6. Remove the jack from the transmission.
  7. Install the front compartment front sight shield. Front Compartment Front Sight Shield Replacement
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals