Rocker Panel Molding Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open both front and rear side doors.
1	Front Wheelhouse Liner Retainer
2	Rear Wheelhouse Liner Retainer (Qty: 2)
3	Rear Tire Front Air Deflector Screw CAUTION: Refer to Fastener Caution .
4	Rocker Panel Molding Procedure Release the 2 rocker panel molding retainers from the front fender. From the bottom edge firmly pull down the rocker panel molding (6 retainers) from the rocker outer panel. From the top edge firmly pull out the rocker panel molding (12 retainers) from the body side outer panel and remove from the vehicle.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Tire and Wheel Removal and Installation Open the front and rear side doors.
1	Front Wheelhouse Liner Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Rear Wheelhouse Liner Bolt [4x] Tighten 2.5 N.m (22 lb in)
3	Rocker Panel Molding Procedure Using the appropriate tool, release the retainers from the bottom edge and pull down the rocker panel molding from the body side outer panel. Using the appropriate tool, release the retainers from the top edge, pull out the rocker panel molding from the body side outer panel and remove from the vehicle. Close the front and rear side doors.