Rear Seat Cushion Removal and Installation

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Seat Cushion Procedure Release the rear center seat belt from the anchor by depressing the tab on the side using a suitable flat-bladed tool. Pull up on the front of the rear seat to disengage the retainers. A high amount of force will be required. Pull out the rear of the seat from the wire retainers. Route the seat belts through the seat bottom. Disconnect the electrical connector, if equipped. Remove the rear seat. Inspect each high retention retainer and sheet metal interface for flushness. Replace retainer as required if damage occurs during removal.

Callout

Component Name

Rear Seat Cushion

Procedure

Release the rear center seat belt from the anchor by depressing the tab on the side using a suitable flat-bladed tool.
Pull up on the front of the rear seat to disengage the retainers. A high amount of force will be required.
Pull out the rear of the seat from the wire retainers.
Route the seat belts through the seat bottom.
Disconnect the electrical connector, if equipped.
Remove the rear seat.
Inspect each high retention retainer and sheet metal interface for flushness. Replace retainer as required if damage occurs during removal.