LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> CTS Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Back Cushion Removal and Installation (40% with AM9)

Rear Seat Back Cushion Removal and Installation (40% with AM9)

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
GM2814757Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the rear seat back bolster. Refer to Rear Seat Back Bolster Replacement .
1 Rear Seat Back Hinge Pivot Bolt

Procedure

  1. Pull the rear seat back cushion latch release located on the top of the rear seat back cushion, and fold the rear seat back cushion forward.
  2. Push in on the rear seat back cushion pivot bolt and release from bracket.
2 Rear Seat Back Cushion

Procedure

  1. Pull up on the outer side of the rear seat back cushion and remove the rear seat back cushion from the bracket and hinge.
  2. Disconnect the electrical connector, if equipped.
  3. Transfer components as necessary.
scientia non olet · About LEMON Manuals