LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> CTS Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Automatic Transmission - 8L45 (M5N) Or 8L90 (M5U) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P176B-P176D >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter: 9V Reference 1 Circuit Status = OK
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Road test the vehicle.
  4. Verify the scan tool parameter: Transmission Intermediate Speed Sensor = The value should change smoothly and gradually as the vehicle speed is increased and decreased.
    • If the value does not change smoothly and gradually 

      Refer to: Circuit/System Testing

    • Go to next step: If the value changes smoothly and gradually 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data. Verify the DTC does not set.
    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  6. All OK.
scientia non olet · About LEMON Manuals