Stabilizer Shaft Insulator Replacement (Non V-Series With AWD Only)

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Front Compartment Lower Noise Shield Replacement (AWD) Engine Lower Front Splash Shield Replacement Front Stabilizer Shaft Link @ Front Stabilizer Shaft - Separate [2x] - Stabilizer Shaft Link Replacement (Non V-Series)
1	Front Stabilizer Shaft Insulator Clamp Nut [2x] CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
2	Front Stabilizer Shaft Insulator Clamp
3	Front Stabilizer Shaft Insulator NOTE: Ensure the NEW front stabilizer shaft insulator is aligned the same way as the OLD insulator before installing.