Transmission End Play Measurement Set Up (Step 2)

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Turbine Shaft Procedure Rotate the transmission so the turbine shaft is facing up. Install the DT-48056 Spring Compressor Bridge with two 16 in 5/16 - 18 threaded rods, nuts and washers, as shown. Install the DT-50903 Clutch Travel Load Gauge and secure with the DT-48056 Spring Compressor Bridge forcing screw. Install the GE-8001 Dial Indicator Set in a suitable location. Special Tools DT-48056 Spring Compressor Bridge DT-50903 Clutch Travel Load Gauge GE-8001 Dial Indicator Set Equivalent regional tools: Special Tools

Callout

Component Name

Turbine Shaft

Procedure

Rotate the transmission so the turbine shaft is facing up.
Install the DT-48056 Spring Compressor Bridge with two 16 in 5/16 - 18 threaded rods, nuts and washers, as shown.
Install the DT-50903 Clutch Travel Load Gauge and secure with the DT-48056 Spring Compressor Bridge forcing screw.
Install the GE-8001 Dial Indicator Set in a suitable location.

Special Tools

DT-48056 Spring Compressor Bridge
DT-50903 Clutch Travel Load Gauge
GE-8001 Dial Indicator Set

Equivalent regional tools: Special Tools