Transmission End Play Measurement Set Up (Step 1)

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Output Shaft Procedure NOTE: There are a number of various output shaft lengths and extension housing configurations, which may require using different length threaded rods to be used with the GE-8433-1 Puller Bar. The illustration depicted only shows one such configuration. Install the GE-8433-1 Puller Bar and thrust bearing from DT-45124 Removal Bridge with two 16 in M10 x 1.5 threaded rods, nuts, and washers, as shown. Loosely tighten the forcing screw on GE-8433-1 Puller Bar. Special Tools DT-45124 Removal Bridge GE-8433-1 Puller Bar Equivalent regional tools: Special Tools

Callout

Component Name

Output Shaft

Procedure

NOTE:

There are a number of various output shaft lengths and extension housing configurations, which may require using different length threaded rods to be used with the GE-8433-1 Puller Bar. The illustration depicted only shows one such configuration.

Install the GE-8433-1 Puller Bar and thrust bearing from DT-45124 Removal Bridge with two 16 in M10 x 1.5 threaded rods, nuts, and washers, as shown.
Loosely tighten the forcing screw on GE-8433-1 Puller Bar.

Special Tools

DT-45124 Removal Bridge
GE-8433-1 Puller Bar

Equivalent regional tools: Special Tools