Transmission Case Front Cover and Drive Link Installation
WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Front Support Cover Gasket Procedure Install a NEW gasket. Do NOT reuse the old gasket. |
| 2 | Drive Sprocket Thrust Washer - Rear |
| 3 | Drive Sprocket |
| 4 | Drive Link |
| 5 | Drive Sprocket Thrust Washer - Front |
| 6 | Automatic Transmission Case Front Cover Seal Procedure Install a NEW seal. Do NOT reuse the old seal. |
| 7 | Automatic Transmission Case Front Cover Procedure Ensure the drive link assembly is not pinched by the front cover and moves freely on the drive sprocket. |
| 8 | Automatic Transmission Case Front Cover Bolt M6 x 30 [11x]
CAUTION:
Refer to Fastener Caution . Procedure Install NEW bolts. Do NOT reuse old bolts. Tighten in sequence 9.5 N.m (84 lb in) |