Output Shaft Bearing Removal (Rear Wheel Drive Models Only)

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Output Shaft Bearing Procedure Assemble the tools as shown. Use the GE-8433 Puller Bar with threaded rod, nut, washer and bearing from DT-45124 Removal Bridge. Ensure the feet of DT-26941 Busing and Bearing Remover are properly engaged with the bearing. Special Tools DT-26941 Busing and Bearing Remover DT-45124 Removal Bridge DT-45124-9 Puller Leg GE-8433 Puller Bar Equivalent regional tools: Special Tools

Callout

Component Name

Output Shaft Bearing

Procedure

Assemble the tools as shown. Use the GE-8433 Puller Bar with threaded rod, nut, washer and bearing from DT-45124 Removal Bridge.
Ensure the feet of DT-26941 Busing and Bearing Remover are properly engaged with the bearing.

Special Tools

DT-26941 Busing and Bearing Remover
DT-45124 Removal Bridge
DT-45124-9 Puller Leg
GE-8433 Puller Bar

Equivalent regional tools: Special Tools