4-5-6-7-8 Reverse Clutch Piston Installation

WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of 4-5-6-7-8 Reverse Clutch Piston Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
CAUTION: Refer to Seal Reuse Caution .
1	4-5-6-7-8-Reverse Clutch Piston Seal Procedure Install a NEW seal. Do NOT reuse the old seal.
2	4-5-6-7-8-Reverse Clutch Piston Stop Procedure Position the stop in the orientation observed during removal.
3	4-5-6-7-8-Reverse Clutch Piston
4	4-5-6-7-8-Reverse Clutch Piston Return Spring Procedure Position the spring in the orientation observed during removal.
5	4-5-6-7-8-Reverse Clutch Piston Seal Procedure Install a NEW seal. Do NOT reuse the old seal.
6	4-5-6-7-8-Reverse Clutch Piston Dam
7	4-5-6-7-8-Reverse Clutch Piston Dam Retaining Ring Procedure Install a NEW retaining ring, it is not reusable. The points on the retaining ring should face up. It may be helpful to loosely install the retaining ring before installing the tool. Special Tools DT-35512 Bearing Installer DT-50900 Clutch Travel Support Fixture DT-50902 Adjustable Clutch Spring Compressor Equivalent regional tools: Special Tools