Front Seat Cushion Cover and Pad Replacement (With W2E)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: The passenger seat cushion assembly is serviced in a kit with the airbag front passenger presence module, cushion pad (and if equipped, heat mat, vent mat, vent mat support, comfort pads). All components in the service kit are assembled and calibrated as a unit and must be replaced as a complete assembly to prevent possible injury to the occupant. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Preliminary Procedures Front Seat Inner Recliner Finish Cover Replacement Driver or Passenger Seat Cushion Outer Finish Panel Replacement (With W2E)
1	Front Seat Cushion Cover Procedure Disengage the J-channel retainers from the seat cushion frame. Disconnect electrical connectors, if equipped. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
2	Front Seat Cushion Heater{ If equipped }
3	Front Seat Cushion Pad Procedure Control Module References for programming and setup information, if required. NOTE: The cushion cover and pad are serviced as a kit. None of the components are intended to be serviced separately.