Transmission Case Front Cover and Drive Link Removal

Special Tools

• GE-8433  Puller Bar

Equivalent regional tools: Special Tools

1. Fig 1: Exploded View Of Transmission Case Front Cover And Drive Link Removal Components

   Courtesy of GENERAL MOTORS COMPANY

   Automatic Transmission Case Front Cover Bolt (1) - Remove and DISCARD M6 x 30 [11x]

2. Use the GE-8433  Puller Bar and 2 bolts in the threaded holes of the automatic transmission front cover to remove it from the case.
3. Automatic Transmission Case Front Cover (2) - Remove
4. Automatic Transmission Case Front Cover Seal (3) - Remove and DISCARD
5. Drive Sprocket Thrust Washer- Front (4) - Remove
6. Drive Sprocket (5) - Remove
7. Drive Link - Remove
8. Drive Sprocket Thrust Washer- Rear (6) - Remove
9. Automatic Transmission Front Support Cover Gasket (7) - Remove and DISCARD