Auxiliary Fluid Accumulator Removal (With Stop/Start)
- WARNING:
The automatic transmission fluid accumulator may be pressurized greater than 120 psi (827 kpa) and fluid may be hot. When servicing accumulator, key must be OFF for a minimum of 10 minutes. Do not open bleeder screw until instructed to do so or personal injury may result.
- Disconnect the electrical connector indicated by arrow.
- Securely attach a hose from the automatic transmission auxiliary fluid accumulator bleeder valve (1) into an approved container.
- Slowly loosen automatic transmission auxiliary fluid accumulator bleeder valve (1) until pressure begins to release.
- Allow all pressure and fluid to be released from the automatic transmission auxiliary fluid accumulator (2).
- Control Valve Lower Body Bolt (3) - Remove [3x]
- Automatic Transmission Auxiliary Fluid Accumulator (2) - Remove
Automatic Transmission Auxiliary Fluid Accumulator Bolt (1) - Remove [2x]
- Automatic Transmission Auxiliary Fluid Accumulator Solenoid (2) - Remove
- Automatic Transmission Auxiliary Fluid Accumulator Bleeder Valve (3) - Remove