Diagnostic Fault Information

NOTE:

DTC P2808 will set with a hydraulic/mechanical condition.
DTC P2809 will set with a hydraulic/mechanical condition or high resistance in the circuit of the component Q77G without setting component/control circuit DTCs.
The components are listed from the least to the most intrusive to service.
Verify the conditions listed in the table do not exist

Component	DTC	Condition
Q77G Transmission Control Solenoid Valve 7	P2808, P2809	Binding or Sticking Stuck Visible Damage
Torque Converter Clutch Regulator Valve	P2808, P2809	Binding or Sticking Debris on the component. Mechanically damaged Restricted/Leaking - Screen or Fluid/oil passage
Torque Converter Clutch Control Valve	P2808, P2809	Binding or Sticking Debris on the component. Mechanically damaged
Torque Converter	P2808, P2809	Leaking - Gasket/O-Ring/Seal Binding or Sticking Mechanically damaged Restricted/Leaking - Fluid/oil passage