Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Perform the scan tool control function: Transmission Accumulator Solenoid Valve - On and Off
Verify the scan tool parameter:
- Transmission Accumulator Solenoid Valve Control Circuit High Voltage Test Status = Not Run or OK
- Transmission Accumulator Solenoid Valve Control Circuit Low Voltage Test Status = Not Run or OK
- Transmission Accumulator Solenoid Valve Control Circuit Open Test Status = Not Run or OK
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Perform the scan tool control function: Transmission Accumulator Solenoid Valve - On and Off
Verify the component turns On and Off: Transmission Accumulator Solenoid Valve
Verify the scan tool parameter: Transmission Accumulator Solenoid Valve Command = On and Off
Verify a click can be heard or felt at the following component(s) when the scan tool control function was commanded: Transmission Accumulator Solenoid Valve
- If the component does not turn On and Off
- If the parameter state does not change
- If a click cannot be heard or felt
Refer to: Circuit/System Testing
- Go to next step: If the component turns On and Off
- Go to next step: If the parameter state changes
- Go to next step: If a click can be heard or felt
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.