Conditions for Running the DTC

P0716

• DTC P0101, P0102, P0103, P0121, P0122, P0716, P07BF, or P07C0 = Not set
• Accelerator Pedal Position Signal from Engine Control Module = Greater than 5%
• Battery Voltage = Greater than 9 V
• Engine Torque = Greater than 30 Nm (22 lb ft)
• Transmission ISS = Greater than 170 RPM
• Transmission OSS = Greater than 214 RPM

Frequency the DTC runs = Continuously - After the running conditions are met

P0717

• DTC P0101, P0102, P0103, P0716, P0722, P0723, P077C, P0770, P07BF or P07C0 = Not set
• Accelerator Pedal Position Signal from Engine Control Module = Greater than 5%
• Battery Voltage = Greater than 9 V
• Engine Torque = Greater than 30 Nm (22 lb ft)
• Transmission OSS = Greater than 68 RPM - Gear 1, 2, 3, 4, 5
• Transmission OSS = Greater than 214 RPM - Gear 6, 7, 8

Frequency the DTC runs = Continuously - After the running conditions are met

P07BF, P07C0

• { P07BF } DTC P07C0 = Not pending
• { P07C0 } DTC P07BF = Not pending
• Battery Voltage = 11 to 32 V

Frequency the DTC runs = Continuously - After the running conditions are met