Component Testing
- Ignition/Vehicle - Off
- Remove the component: Automatic Transmission Fluid Pan
- Remove the component: Control Valve Assembly
- Disconnect the electrical connector: X176
- Test for 65 to 47, 000 ohms between the test points: Signal circuit Terminal 14 & Low Reference Terminal 16 @ X176
- If not between 65 and 47, 000 ohms
Replace the component: B13 Transmission Fluid Temperature Sensor
- Go to next step: If between 65 and 47, 000 ohms
- If not between 65 and 47, 000 ohms
- All OK.
NOTE:
Testing for steps 4 to 7 is performed on the component side of the harness connector.