Crankshaft Balancer Removal (LGX)

Preliminary Procedure

1. Install the EN-46106  Flywheel Holding Tool through the starter mounting hole.
   NOTE:

   The top starter hole will require a longer bolt and nut to secure the tool.

2. Remove and discard the crankshaft balancer bolt.
3. Install the EN-44226-5  Crankshaft Button in the nose of the crankshaft.
4. Install the EN-25031  3 Jaw Puller
   NOTE:

   Use the EN-41816  Crankshaft Balancer Remover with the extension arms removed as an alternate method for removing the crankshaft balancer.

5. Tighten the center bolt of the EN-25031  3 Jaw Puller in order to pull the crankshaft balancer off of the crankshaft.
6. Remove the EN-25031  3 Jaw Puller remover from the crankshaft balancer.
7. Remove the EN-46106  Flywheel Holding Tool through the starter mounting hole.

Special Tools

• EN-25031  3 Jaw Puller
• EN-41816  Crankshaft Balancer Remover
• EN-44226-5  Crankshaft Button
• EN-46106  Flywheel Holding Tool