Propeller Shaft Transmission Flange Fluid Seal Replacement (All Wheel Drive)

GM4073829

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Preliminary Procedures
Transfer Case Assembly Replacement .

1

Propeller Shaft Transmission Flange Fluid Seal

Procedure

Use the J-6125-B hammer and J-36825-A remover to remove the seal. Use care in order to avoid damaging the output shaft bushing.
Lubricate the seal with clean transmission fluid.
Use the DT-50648 installer to install the seal.

Special Tools

DT-50648 Case Seal Installer
J-6125-B Slide Hammer with Adaptor
J-36825-A Output Shaft Oil Seal Remover

For equivalent regional tools, refer to Special Tools .