Crankshaft Balancer Removal (LF4)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Install the EN-46106 Flywheel Holding Tool through the starter mounting hole. Remove and discard the crankshaft balancer bolt. Install the EN-38416-2 Crankshaft Button in the nose of the crankshaft. Install the J-24420-C Crankshaft Balancer Remover in order to remove the crankshaft balancer. Tighten the center bolt of the EN-41816 Crankshaft Balancer Remover in order to pull the crankshaft balancer off of the crankshaft. Remove the J-24420-C Crankshaft Balancer Remover from the crankshaft balancer. Remove the EN-46106 Flywheel Holding Tool through the starter mounting hole. Special Tools EN-38416-2 Crankshaft Button J-24420-C Crankshaft Balancer Remover EN-46106 Flywheel Holding Tool Equivalent regional tools: Special Tools (LF4)
1	Crankshaft Balancer Bolt Procedure Remove and DISCARD the crankshaft balancer bolt.
2	Crankshaft Balancer

Callout

Component Name

Preliminary Procedures

Install the EN-46106 Flywheel Holding Tool through the starter mounting hole.
Remove and discard the crankshaft balancer bolt.
Install the EN-38416-2 Crankshaft Button in the nose of the crankshaft.
Install the J-24420-C Crankshaft Balancer Remover in order to remove the crankshaft balancer.
Tighten the center bolt of the EN-41816 Crankshaft Balancer Remover in order to pull the crankshaft balancer off of the crankshaft.
Remove the J-24420-C Crankshaft Balancer Remover from the crankshaft balancer.
Remove the EN-46106 Flywheel Holding Tool through the starter mounting hole.

Special Tools

Equivalent regional tools: Special Tools (LF4)

Crankshaft Balancer Bolt
Procedure
Remove and DISCARD the crankshaft balancer bolt.

Crankshaft Balancer