Water Pump Pulley Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Water Pump Pulley Procedure Install the EN-46104 Water Pump Pulley Holding Tool onto the water pump pulley mounting holes. Remove the water pump pulley bolts. Remove the EN-46104 Water Pump Pulley Holding Tool from the water pump pulley. Special Tool EN-46104 Water Pump Pulley Holding Tool Equivalent regional tools: Special Tools (LGX)
2	Water Pump Pulley Bolt [4x] Tighten 10 N.m (89 lb in)

Callout

Component Name

Water Pump Pulley

Procedure

Install the EN-46104 Water Pump Pulley Holding Tool onto the water pump pulley mounting holes.
Remove the water pump pulley bolts.
Remove the EN-46104 Water Pump Pulley Holding Tool from the water pump pulley.

Special Tool
EN-46104 Water Pump Pulley Holding Tool
Equivalent regional tools: Special Tools (LGX)

Water Pump Pulley Bolt [4x]
Tighten
10 N.m (89 lb in)