Cylinder Head Installation - Left Side (LGX)
WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Cylinder Head Installation Components With Tightening Sequence - Left Side (LGX)
| Callout | Component Name |
|---|---|
| 1 | Cylinder Head Gasket Procedure Install a NEW gasket. |
| 2 | Cylinder Head |
| 3 | Cylinder Head Bolt M8 x 80.8 [2x]
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Install NEW bolts. Do NOT reuse old bolts. Tighten in sequence
Special Tools EN-45059 Angle Meter Equivalent regional tools: Special Tools (LGX) . |
| 4 | Cylinder Head Bolt M11 x 178 [8x]
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Install NEW bolts. Do NOT reuse old bolts. Tighten in sequence
|