Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install a 5/8 inch washer (2) onto the EN-38836 or equivalent. The washer serves as a stop against the crankshaft face and will assist in installing the bearing to the proper depth.
Install the new pilot bearing (1) onto the tool.
Courtesy of GENERAL MOTORS COMPANY

Install a new pilot bearing into the crankshaft using the EN-38836 .

NOTE:

Installing the replacement pilot bearing to the proper depth is critical.

Inspect the clutch pilot bearing for proper installation. A properly installed clutch pilot bearing will be installed to a depth of (a) 2.0 mm (+/-.3) mm from the crankshaft flange face.