LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> ATS Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (ENGINE MECHANICAL - 3.6L (LGX LF4) - REPAIR INSTRUCTIONS - OFF VEHICLE (1 Of 2)) >> Repair Instructions - Off Vehicle >> Water Pump Removal (LF4)

Water Pump Removal (LF4)

WARNING: This page is about a different variant/trim than selected.
GM4596862Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Water Pump Pulley Bolt [4x]

Procedure

  1. Install the EN-46104  Water Pump Pulley Holding Tool onto the water pump pulley mounting holes.
  2. Remove the water pump pulley bolts.
  3. Remove the EN-46104  Water Pump Pulley Holding Tool from the water pump pulley.

Special Tools 
EN-46104  Water Pump Pulley Holding Tool
Equivalent regional tools: Special Tools (LF4)
2 Water Pump Pulley
3 Water Pump Bolt [6x]
CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

NOTE:

Remove and DISCARD the bolts.
4 Water Pump
5 Water Pump Gasket
NOTE:

Remove and DISCARD the gasket.
scientia non olet · About LEMON Manuals