Engine Front Cover Assemble (LF4)

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Camshaft Position Actuator Solenoid Valve Seal [4x] Procedure Place the seal into position with the notches in the seal down. The notches will face inboard when properly installed. Install - Camshaft Position Actuator Solenoid Valve Seal EN-46103 Camshaft Actuator Valve Seal Installer NOTE: Install a NEW seal. Do NOT reuse the old seal. Special Tools EN-46103 Camshaft Actuator Valve Seal Installer Equivalent regional tools: Special Tools (LF4)
2	Crankshaft Front Oil Seal Procedure Install - Crankshaft Front Oil Seal EN-29184 Oil Seal Installer NOTE: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal. Special Tools EN-29184 Oil Seal Installer Equivalent regional tools: Special Tools (LF4)
3	Engine Front Cover Gasket NOTE: Install a NEW gasket. Do NOT reuse the old gasket.

Callout

Component Name

Camshaft Position Actuator Solenoid Valve Seal [4x]

Procedure

Place the seal into position with the notches in the seal down. The notches will face inboard when properly installed.
Install - Camshaft Position Actuator Solenoid Valve Seal EN-46103 Camshaft Actuator Valve Seal Installer

NOTE:

Install a NEW seal. Do NOT reuse the old seal.

Special Tools
EN-46103 Camshaft Actuator Valve Seal Installer
Equivalent regional tools: Special Tools (LF4)

Crankshaft Front Oil Seal

Procedure

NOTE:

Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

Special Tools
EN-29184 Oil Seal Installer
Equivalent regional tools: Special Tools (LF4)

Engine Front Cover Gasket

NOTE:

Install a NEW gasket. Do NOT reuse the old gasket.