Crankshaft Balancer Removal (LGX)
WARNING: This page is about a different variant/trim than selected.
 Courtesy of GENERAL MOTORS COMPANY
|
| Callout |
Component Name |
|
Preliminary Procedure
- Install the EN-46106
Flywheel Holding Tool through the starter mounting hole.
NOTE:
The top starter hole will require a longer bolt and nut to secure the tool.
- Remove and discard the crankshaft balancer bolt.
- Install the EN-44226-5
Crankshaft Button in the nose of the crankshaft.
- Install the EN-25031
3 Jaw Puller
NOTE:
Use the EN-41816
Crankshaft Balancer Remover with the extension arms removed as an alternate method for removing the crankshaft balancer.
- Tighten the center bolt of the EN-25031
3 Jaw Puller in order to pull the crankshaft balancer off of the crankshaft.
- Remove the EN-25031
3 Jaw Puller remover from the crankshaft balancer.
- Remove the EN-46106
Flywheel Holding Tool through the starter mounting hole.
Special Tools
- EN-25031
3 Jaw Puller
- EN-41816
Crankshaft Balancer Remover
- EN-44226-5
Crankshaft Button
- EN-46106
Flywheel Holding Tool
Equivalent regional tools: Special Tools (LGX) |
| 1 |
Crankshaft Balancer Bolt
Procedure
Remove and DISCARD the bolt. |
| 2 |
Crankshaft Balancer |