Crankshaft Balancer Removal (LF4)
WARNING: This page is about a different variant/trim than selected.
 Courtesy of GENERAL MOTORS COMPANY
|
| Callout |
Component Name |
|
Preliminary Procedures
- Install the EN-46106
Flywheel Holding Tool through the starter mounting hole.
- Remove and discard the crankshaft balancer bolt.
- Install the EN-38416-2
Crankshaft Button in the nose of the crankshaft.
- Install the J-24420-C
Crankshaft Balancer Remover in order to remove the crankshaft balancer.
- Tighten the center bolt of the EN-41816
Crankshaft Balancer Remover in order to pull the crankshaft balancer off of the crankshaft.
- Remove the J-24420-C
Crankshaft Balancer Remover from the crankshaft balancer.
- Remove the EN-46106
Flywheel Holding Tool through the starter mounting hole.
Special Tools
- EN-38416-2
Crankshaft Button
- J-24420-C
Crankshaft Balancer Remover
- EN-46106
Flywheel Holding Tool
Equivalent regional tools: Special Tools (LF4) |
| 1 |
Crankshaft Balancer Bolt
Procedure
Remove and DISCARD the crankshaft balancer bolt. |
| 2 |
Crankshaft Balancer |