Camshaft Removal - Left Side (LF4)
WARNING: This page is about a different variant/trim than selected.
Observe the markings on the bearing caps. Each bearing cap is marked in order to identify its location. The markings have the following meanings:
- The raised feature must always be oriented toward the center of the cylinder head.
- The I indicates the intake camshaft.
- The E indicates the exhaust camshaft.
- The number indicates the journal position from the front of the engine.
Remove the camshaft bearing cap bolts.
- Remove the camshaft bearing caps.
- NOTE:
Mark the camshafts upon removal to ensure installation is in the correct position.
Remove the camshafts.